Remove the Cable Management Arm
5.
Disconnect connector.
a.
Place your left arm under the CMA to support it.
b.
Use your right thumb to push in (toward the right) on the connector C
release tab labeled PUSH (callout 1), and pull connector C out of the right
slide rail (frame 1 and 2).
No. Description
1 Connector C release tab (labeled PUSH)
6.
Disconnect connector B.
a.
Place your right arm under the CMA to support it and grasp the rear end of
connector B with your right hand.
Preparing for Service 45
To Next Page
Loading...
