March 2006 910-257C
MG2 Series Page 6-1
6 SPECIFICATIONS
THICKNESS
MEASUREMENT
RANGE:
0.020 to 25.000 inches or
0.50 to 635.0 mm (typical in steel)
THICKNESS DISPLAY
RESOLUTION:
Standard
Low
• Millimeters: 0.01 0.1
• Inches: 0.001 0.01
MEASUREMENT
RATE:
Standard Mode - 4 measurements
per second
Fast Min Mode - 20 measurements
per second
MATERIAL VELOCITY
RANGE:
0.0200 - 0.7362 in/µS
0.508 - 18.699 mm/µS
TRANSDUCER ZERO
COMPENSATION:
Provides zero and temperature
compensation for different
transducers.
NOTE: Thickness range depends on material, transducer type,
surface condition, surface preparation, and temperature.
To Next Page