March 2006 910-257C
MG2 Series Page 4-15
To change radix:
Step 1: Press [2ndF][ ](Setup) to display the setup tabs.
Step 2: Use the [ , ] keys to highlight the System tab.
Step 3: Use the [ ] key to highlight Radix and [ , ] to select
between Period and Comma.
Step 4: Press [MEAS] to return to the Measure Mode.
4.6.4 Backlight Mode
Backlight Mode allows the user to determine how the backlight works
once it has been turned on. When Backlight Mode is set to Normal,
the backlight will stay on until it is turned off. When Backlight Mode
is set to Auto and the backlight is turned on, it will stay on while a
thickness measurement is being displayed and automatically turn off
five (5) seconds after a LOS (Loss of Signal) has occurred.
To Change Backlight Mode:
Step 1: Press [2ndF][ ](Setup) to display the setup tabs.
Step 2: Use the [ , ] keys to highlight the System tab.
Step 3: Use the [ ] key to highlight Backlight Mode and [ , ]
to select between Normal and Auto.
Step 4: Press [MEAS] to return to the Measure Mode.
To Next Page
Loading...
