910-257C March 2006
Page 4-14 MG2 Series
Step 4: Press [MEAS] to return to the Measure Mode.
4.6.2 Inactive Time
Inactive Time allows the user to set the Auto Power Off feature to
either On or Off. When Inactive Time is set to On, the MG2 Series
gage powers off after approximately six (6) minutes during which no
thickness measurements or key presses have occurred. When Inactive
Time is set to Off, the MG2 Series unit remains powered up until the
user turns the unit Off or the battery voltage becomes low.
To change Inactive Time:
Step 1: Press [2ndF][ ](Setup) to display the setup tabs.
Step 2: Use the [ , ] keys to highlight the System tab.
Step 3: Use the [ ] key to highlight Inactive Time and [ , ] to
select between Off and On.
Step 4: Press [MEAS] to return to the Measure Mode.
4.6.3 Radix
Radix allows the user to select the display of the radix character (the
character that separates the whole and decimal part of the thickness
value). In the United States, the period (.) is used as radix (Example:
0.123"). In many other countries, the comma (,) is used (Example:
1,25 mm).
To Next Page
Loading...
