March 2006 910-257C
MG2 Series Page 4-27
Step 11: Press [ ] or [ENTER] to scroll to Waveform Fill.
Step 12: Press [ , ] to choose between Off and On.
Step 13: Press [MEAS/RESET].
Note: When the Waveform has been enabled and the Zoom
feature is turned off, the user can adjust the range and
delay of the waveform by using the [ ] or [ ] key to
change the range to the next higher or lower range set
point or the [ , ] keys to increase or decrease the
waveform delay.
4.13 Waveform Adjust Mode (MG2-XT
and MG2-DL Only)
The Waveform Adjust Mode feature allows the user to make Setup
adjustments that are not available in the Standard Mode.
Additional measurement capabilities include:
• Manual Gain adjustment in 1 dB increments
• Extended Blank
• Echo Blank (Manual Echo-to-Echo only)
• Range
• Delay
Note: These features can be activated only while the optional
To Next Page
Loading...
