Panametrics MG2 - Opening a File

March 2006 910-257C
MG2 Series Page 5-15
, ] editing function. Press [ENTER].
Step 9: Use the [ ] key to enter the Start ROW using the [ , ,
, ] editing function. Press [ENTER].
Step 10: Use the [ ] key to enter the END ROW using the [
] editing function. Press [ENTER].
Step 11: Use the [ and ] keys to select Standard or EPRI.
Press [ENTER]. In Standard mode, the columns after Z
increment [AA, AB, AC, …]. In EPRI mode, the columns
after Z will increment [AA, BB, CC…].
Step 12: Use the [ and ] keys to select to increment first by
Row or Column. Press [ENTER].
Step 13: Use the [ and ] keys to select Done or Cancel. Press
[ENTER].
5.4 Opening a File
Use the File Open function to retrieve a file stored in the datalogger and
mark it as the active file in the Measure Mode.
To open a File, follow these steps:
Step 1: Press [2
nd
F][ ](FILE) to go to the File Tabs.
Step 2: Press [ ] to scroll to the Open tab.
Step 3: Press [ ] to enter the Open tab.
Step 4: Use [ ] or [ ] to scroll files.
Step 5: Press [ENTER] to select the file.