Panametrics MG2 - Clock Setup (MG2-DL Only)

910-257C March 2006
Page 4-18 MG2 Series
Note: The Alarm Mode and the Diff Mode are mutually exclu-
sive (cannot be used at the same time). If one of these
function is activated, it will be automatically turned off
if the other function is turned on.
To activate Diff Mode:
Step 1: Press [2ndF][ ](Setup) to display the setup tabs.
Step 2: Use the [ , ] keys to highlight the Diff tab.
Step 3: Use the [ ] key to highlight Enable and [ , ] to select
On or Off.
Step 4: Press the [ENTER] key and then use the [ ] key to
highlight Diff Value. Use the [ , ,
, and ] keys to
slew to the Diff set point.
Step 5: Press [MEAS] to return to the Measure Mode.
4.9 Clock Setup (MG2-DL Only)
The clock is used to set the internal date and time for the MG2-DL, so
that a time and date stamp can be given to a data file. The time and
date stamp indicates when data was last stored in a file.
To set the internal date and clock:
Step 1: Press [2ndF][ ](Setup) to display the setup tabs.
Step 2: Use the [ , ] keys to highlight the Clock tab.