March 2006 910-257C
MG2 Series Page 5-17
The ID number is automatically updated to the next ID number in the
sequence. The new ID number is indicated on the display. If the ID
number cannot be updated, a long beep sounds and the gage displays a
message explaining why the ID was unable to update. In this case, the ID
number on the display remains unchanged.
Some of the special features of the MG2-DL allow the gage to store more
than one thickness value at an ID location. For this reason, the gage has
two file types for saving data:
• Normal: Standard one thickness saved.
• THRU COAT
®
: Thickness of coating and thickness of steel
saved.
The gage will not store different file type data in a single file.
5.6 Using the Review ID Mode
The review ID mode has two purposes:
• Review datalogger contents by scanning through stored ID
locations in the active file.
• Move within the file and change the current ID location to any
location that already exists in the file.
To review stored thickness values or move to an existing ID location,
follow these steps:
Step 1: Press [2
nd
F][ ](ID#).
Step 2: Use [ ] or [ ] to change ID.
To Next Page
Loading...
