910-257C March 2006
Page 1-4 MG2 Series
The gages employ a full range of user-controlled display functions to
measure the thickness of corroded, pitted, scaled, granular, and other
difficult materials from one side only. A full line of transducers is
available to measure materials between 0.020” (0.50mm) and 25”
(635mm) thickness and between -20°C and +500°C in temperature.
The MG2 series makes full use of its microprocessor to offer
selectable, advanced measurement features. Moreover, the MG2
Series continuously adjusts the receiver setup so that every
Gain Adjust
••
Auto Sensitivity Gain Optimiza-
tion
••
Differential Mode
••
THRU-COAT
®
••
Echo-to-Echo
••
Hi-Low Alarm
••
Internal Datalogger
•
Live Waveform Option
••
USB
Note: The USB port on the MG2 and MG2-
XT is used for internal software upgrade
only.
• • •
Table 1: MG2 Series Features
MG2 Series Features
MG2 MG2-XT MG2-DL
To Next Page
Loading...
