910-257C March 2006
Page 4-20 MG2 Series
The parameters that are reset and their reset values are:
• Material Velocity (0.2260 in/µsec)
• Transducer Zero
• Measure Option (Standard)
• Unit (Inches)
• Resolution (Standard)
•Min/Max (Off)
• Hold/Blank (Blank)
• Measure Rate (Normal)
•CAL Lock (Off)
• ID Overwrite (Off) MG2-DL only
•Beeper (On)
• Inactive Time (On)
• Radix (Period)
• Backlight Mode (Normal)
• 36DLP Output (Off) (MG2-DL only)
• Alarm (Off). Default Values: Low 0.000; High 25.000
• Diff (Off). Default Value 0.000
To perform Measurement Resets:
Step 1: Press [2ndF][ ](Setup) to display the setup tabs.
To Next Page
Loading...
