Panametrics MG2 - Page 87

March 2006 910-257C
MG2 Series Page 5-7
and extending leftward to the first punctuation mark or to the left-
most character (whichever is first) can increment.
• Digits are cycled 0, 1, 2, ..., 9. The 9 to 0 transition is done only after
incrementing the character to the left. Letters are cycled A, B, C, ...,
Z, A, etc. The Z to A transition is done only after incrementing the
character to the left. In either case, if there is no character to the left,
or if the character to the left is a punctuation mark, then the ID
number cannot increment.
• If an ID number cannot increment, after a reading is saved, a long
error beep sounds and the momentary message “CANNOT
INCREMENT” is shown on the display.
Note: To make the gage increment through a range of
numbers several digits wide while beginning with a
single digit ID number, the maximum number of
digit positions must be entered initially using leading
zeroes.
Some examples of automatically generated incremented ID number
series include:
Table 5-1: Five Examples of Automatically Generated
Incremented ID Number Series
1:
Initial
Limit
1
2
3
.
.
.
9