Panametrics MG2 - Page 90

910-257C March 2006
Page 5-10 MG2 Series
To create an Incremental File, follow these steps:
Step 1: Press [2
nd
F][ ](File) to display the File Tabs.
Step 2: Use the [ ] and [ ] keys to select the Create Tab.
Step 3: Use the [ ] key to highlight the file name and press [ ]
to enter a file name using the [ , , , ] editing
function. Press [ENTER].
Step 4: Use the [ and ] keys to select Incremental. Press
[ENTER].
Step 5: Use the [ and ] keys to select Normal or THRU
COAT
®
and press [ENTER]. Normal is for standard files.
THRU COAT is used when storing thru-coat thickness
readings.
Step 6: Use the [ and ] keys to select Continue and then
press [ENTER].
Step 7: Use the [ ] key to enter the start ID number using the
editing function keys [ , , , ]. Press [ENTER].
Step 8: Use the [ , ] to select Done or Cancel. Press
[ENTER].
5.3.3.2 Sequential
A Sequential File is defined by a starting and an ending ID number. The
resulting file is inclusive of the starting and ending points and all points
in between.