Panasonic KX-NS300 - Page 240

Name Description Value Range Links
Extension
Number (SIP
Username)
Specifies the extension number
(SIP Username) of the port.
Max. 5 digits
(consisting of 0–9)
Feature Manual
References
5.2.2 SIP (Session
Initiation Protocol)
Extension
Password Specifies the password used for
registering a SIP Extension to
the PBX. While it is possible to
enter a password manually for
each SIP Extension, you can
copy the value for Extension
Number to Password by
clicking the Copy to button. This
parameter can only be modified
when the virtual SIP extension
port is set to OUS, and the
programmer must be in On-line
mode.
4–16 characters
(consisting of 0–9, a–
z, A–Z)
Feature Manual
References
5.2.2 SIP (Session
Initiation Protocol)
Extension
Connection Indicates the port status. To
change the status of the port,
click the desired cell in the
column, and then select INS or
OUS for the port. This option is
only available in On-line mode.
INS: The port is in
service
OUS: The port is out
of service
Fault: The port is not
communicating with
the network.
Feature Manual
References
5.2.2 SIP (Session
Initiation Protocol)
Extension
FAX Detection
Ability
Enables the use of the FAX
Detection Ability feature.
Disable, Enable
Feature Manual
References
5.2.2 SIP (Session
Initiation Protocol)
Extension
FAX Sending
Method
Specifies the method of
transporting the fax signal.
G.711 Inband, T.38
Feature Manual
References
5.2.2 SIP (Session
Initiation Protocol)
Extension
Maximum Bit
Rate
Specifies the maximum bit rate
of the fax signal.
No Speed Limit, 2400
bps, 4800 bps, 7200
bps, 9600 bps, 12000
bps, 14400 bps
Feature Manual
References
5.2.2 SIP (Session
Initiation Protocol)
Extension
T38 FAX Max
Datagram
Specifies the maximum
datagram size when using the T.
38 protocol.
272–512
Feature Manual
References
5.2.2 SIP (Session
Initiation Protocol)
Extension
9.16 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-SIPEXT
240 PC Programming Manual