Panasonic KX-NS300 - Page 321

Name Description
Value
Range
Links
Unattended
Conference—
Recall Start Timer
(x60s)
Specifies the length of time until
the conference originator
receives an Unattended
Conference Recall tone.
60 × n (n
= 0–60) s
Feature Manual References
2.14.2 Conference
Unattended
Conference—
Warning Tone
Start Timer (s)
Specifies the length of time until
the parties involved in an
Unattended Conference receive
a warning tone after the
conference originator receives
the Unattended Conference
Recall tone but does not return
to the conference.
0–240 s
Feature Manual References
2.14.2 Conference
Unattended
Conference—
Disconnect Timer
(s)
Specifies the length of time until
an Unattended Conference is
disconnected after the parties
involved in the conference
receive a warning tone but the
conference originator does not
return to the conference.
0–240 s
Feature Manual References
2.14.2 Conference
Miscellaneous
Name Description
Value
Range
Links
Caller ID—Waiting to
receive (s)
Specifies the length of time that the
PBX waits to receive Caller ID from
an analogue trunk. If the Caller ID is
received through an analogue trunk
card on which no Caller ID card is
mounted or through a port to which
Caller ID Detection is disabled, this
timer is not applicable.
0–15 s
PC Programming
Manual References
11.1.3 PBX Configuration—
[3-1-3] Group—Trunk Group
—Caller ID Modification
14.1 PBX Configuration—
[6-1] Feature—System
Speed Dial
Feature Manual
References
2.19.1 Caller ID
Caller ID—Visual
Caller ID Display (s)
Specifies the length of time that a
Caller ID number, with the Call
Waiting tone offered by an analogue
line from the telephone company, is
shown on the display. The Caller ID
number flashes on the display for
five seconds, followed by a 10-
second pause, then flashes again
for five seconds.
0–250 s
Feature Manual
References
2.1.3.3 Call Waiting
2.10.4.2 Call Waiting Tone
2.19.1 Caller ID
10.3 PBX Configuration—[2-3] System—Timers & Counters
PC Programming Manual 321