Panasonic KX-NS300 - Page 322

Name Description
Value
Range
Links
Extension PIN—Lock
Counter
Specifies the number of successive
incorrect PIN entries allowed before
the extension PIN is locked. A
locked extension PIN cannot be
used until reset from the extension
assigned as manager. (Specifying
"None" disables this counter.)
None, 1–
15
Feature Manual
References
2.7.5 Walking COS
2.7.6 Verification Code Entry
2.24.1 Extension Personal
Identification Number (PIN)
External Sensor—
Ring Duration (s)
Specifies the length of time that the
PBX waits for the called party to
answer before cancelling a sensor
call.
10 × n
(n=1–15)
s
Feature Manual
References
2.18.3 External Sensor
Incoming Call Inter-
digit Timer—DDI /
DID (s)
Specifies the length of time between
digits when receiving a DDI/DID
number from a public network. The
call will be redirected to a PBX
operator when this timer expires.
0–30 s
PC Programming
Manual References
18.3 PBX Configuration—
[10-3] CO & Incoming Call—
DDI / DID Table
Feature Manual
References
2.1.1.3 Direct Inward Dialling
(DID)/Direct Dialling In (DDI)
Incoming Call Inter-
digit Timer—TIE (s)
Specifies the length of time between
digits when receiving a dialled
number from a TIE line. The call will
be redirected to a PBX operator
when this timer expires.
3–30 s
PC Programming
Manual References
17.1 PBX Configuration—
[9-1] Private Network—TIE
Table
Feature Manual
References
4.3.1 TIE Line Service
PT Display—PT Last
Display Duration in
Idle Mode (s)
Specifies the length of time that the
current information remains on the
display after the extension returns to
idle status.
1–15 s
Air Synchronisation
—Watching
Degeneracy (x60s)
Specifies the length of time that a
Slave CS can maintain an ongoing
call after air synchronisation is lost.
60 × n
(n=0–
300) s
PC Programming
Manual References
19.3.1 PBX Configuration—
[11-3-1] Maintenance—CS
Synchronisation—Air
Synchronisation
Voice Mail (Caller
from VM to CO)—
On-hook Wait Time
(s)
Specifies the length of time from
when the voice mail seizes a trunk
(for example, to transfer a call) until
the voice mail goes on hook. If the
time specified here is too short, the
voice mail will be unable to dial the
number and make a connection.
1–30 s
Feature Manual
References
3.1.1 Unified Messaging
System Overview
10.3 PBX Configuration—[2-3] System—Timers & Counters
322 PC Programming Manual