Panasonic KX-NS300 - Page 574

Notification Parameters
The Unified Messaging system is able to notify a subscriber when a new message is recorded in his or her
mailbox. There are 3 methods the system can use for notification:
– Lighting the Message Waiting Lamp on the subscriber’s extension telephone.
– Calling a pre-programmed device (external telephone, etc.). A maximum of 3 devices (Device 1, 2, 3) can
be programmed per mailbox.
– Sending an e-mail to a designated address.
Name Description Value Range Links
Message
Waiting Lamp
If set to "Enable", the Message Waiting Lamp of
the subscriber’s telephone turns on when a new
message is recorded.
Disable, Enable
Feature
Manual
References
3.2.1.29
Message
Waiting
Notification—
Lamp
Telephone
Device
Specifies the Message Waiting Notification
schedule for each device. The following
parameters can be specified for devices 1, 2,
and 3. Click Edit for the extension to change,
set Device Notification for Unreceived
Message to "Yes", and programme the settings,
then click OK to finish.
Feature
Manual
References
3.2.1.30
Message
Waiting
Notification—
Telephone
Device
Telephone
Device—
Device No. 1,
2, 3—Only
Urgent
Messages
Specifies if notifications will be sent only for
messages designated as urgent.
Yes, No
Feature
Manual
References
3.2.1.30
Message
Waiting
Notification—
Telephone
Device
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
574 PC Programming Manual