7.6 Utility—Activation Key Installation
Activation keys for various features of the PBX can be installed using this screen. Activation key files are copied
from a PC to the PBX and activated. Use the below procedure to install activation key files to a PBX.
This screen can be accessed only in On-line mode.
1. Click Browse and specify the directory where the activation key files are stored, and click Open.
2. A list of activation key files stored in the specified directory is displayed. Check the boxes next to the
activation keys to install to the PBX, and click Install.
3. The activation keys will be copied to the Main unit. When installation is complete, the message, "The
activation key has been installed and activated successfully!" is displayed.
4. Click OK.
Note
You can click the provided link to directly access 9.3 PBX Configuration—[1-1]
Configuration—Slot—Activation Key Status to view activation key information and programme the
number of activated IP-GW trunks and IP softphones.
PC Programming Manual 127
7.6 Utility—Activation Key Installation
To Next Page
Loading...
