27.2.4 Network Service—[2-5] Server Feature—NTP
NTP server settings for use with KX-UT series SIP phones can be programmed.
NTP server
Enables or disables NTP service with the PBX’s NTP server for connected KX-UT series SIP phones.
When this feature is enabled, the PBX will report to connected KX-UT series SIP phones the information
obtained from the SNTP server specified in 10.1.2 PBX Configuration—[2-1-2] System—Date &
Time—SNTP / Daylight Saving.
If this feature is disabled, connected KX-UT series SIP phones will use their individually programmed time
settings.
Value Range
Disable, Enable
Maintenance Console Location
27.2.4 Network Service—[2-5] Server Feature—NTP
PC Programming Manual References
10.1.2 PBX Configuration—[2-1-2] System—Date & Time—SNTP / Daylight Saving— SNTP—SNTP
Server—IP Address
10.1.2 PBX Configuration—[2-1-2] System—Date & Time—SNTP / Daylight Saving— SNTP—SNTP
Server—Port Number
10.1.2 PBX Configuration—[2-1-2] System—Date & Time—SNTP / Daylight Saving— SNTP—Time
Zone—Time Zone
990 PC Programming Manual
27.2.4 Network Service—[2-5] Server Feature—NTP
To Next Page
Loading...
