5.3 System Control—System Reset
When programming changes or other changes to PBX settings require a system reset, this command allows
a reset to be performed remotely from Web Maintenance Console.
When the system is reset, any settings not saved to the System Memory are lost. A backup should be performed
before the reset to ensure no data is lost. However, a backup should not be performed if settings or data have
recently been imported into the system, because performing a backup would overwrite the imported data with
the current PBX settings.
This screen can be accessed only in On-line mode.
1. Confirm the contents of the displayed warning message.
2. Click Backup or Skip according to the system’s status:
• Backup: Click to backup system settings. The system will be reset after the backup has been
performed.
• Skip: The system is reset without performing a backup.
If you are logged in to the PBX that is reset using this command, it is necessary to re-log in to Web Maintenance
Console to continue programming.
72 PC Programming Manual
5.3 System Control—System Reset
To Next Page
Loading...
