14.5 PBX Configuration—[6-5] Feature—Absent
Message
When a display PT user calls an extension, a message is shown on the caller’s telephone display describing
the reason for absence. A maximum of 8 Absent Messages can be programmed, and any extension user can
select one of them.
Note
When using this feature in conjunction with the Unified Messaging (UM) system, changing a message here
will create a difference between the displayed message and the UM’s pre-recorded greeting that
corresponds to the absent message. To use both features in synchronisation, you must record a
corresponding greeting for each absent message changed. For details about changing UM system
prompts, see 7.9 Utility—UM – System Prompts Customisation.
Absent Message
Specifies the message for display.
Value Range
Max. 16 characters
Maintenance Console Location
14.5 PBX Configuration—[6-5] Feature—Absent Message
Feature Guide References
2.20.2 Absent Message
PC Programming Manual 775
14.5 PBX Configuration—[6-5] Feature—Absent Message
To Next Page
Loading...
