16.7 PBX Configuration—[8-7] ARS—Authorisation
Code for TRG
An Authorisation code can be specified for each trunk group. The Authorisation codes entered here can be
added to user-dialled numbers by adding "G" to the Modify Command specified on the Carrier tab of screen
16.5 PBX Configuration—[8-5] ARS—Carrier.
8 trunk groups are displayed on the screen at a time. To display other groups, click the applicable tab.
TRG—TRG 01–TRG 64
Specifies the Authorisation code of each carrier for each trunk group.
Value Range
Max. 10 digits (consisting of 0–9, *, and #)
Maintenance Console Location
16.7 PBX Configuration—[8-7] ARS—Authorisation Code for TRG
PC Programming Manual References
16.5 PBX Configuration—[8-5] ARS—Carrier—Carrier—
Modify Command
Feature Guide References
2.8.1 Automatic Route Selection (ARS)
798 PC Programming Manual
16.7 PBX Configuration—[8-7] ARS—Authorisation Code for TRG
To Next Page
Loading...
