12.1.4 PBX Configuration—[4-1-4] Extension—Wired
Extension—Flexible Button
Overview
Each flexible button can be customised to allow one-touch access to a certain feature. A maximum of 84 flexible
buttons can be customised for each extension. Select the desired extension from the Extension Number /
Name list.
KX-NT505 Flexible Buttons
KX-NT553/KX-NT556 IP-PTs can be connected to up to 4 KX-NT505 48 key add-on units. When an extension
that has one or more KX-NT505 units connected is selected in the Extension Number / Name list, Number
of Connections NT505 and NT505 Location No. are displayed. In Number of Connections NT505, specify
the number of connected KX-NT505 units (a maximum of 4). This configuration is available at the Installer level
only. Then, in NT505 Location No., select a KX-NT505 to program. Up to 48 flexible buttons can be
programmed for each KX-NT505 unit.
Copying Flexible Button Settings
To copy the flexible button settings of an extension to another extension, click Copy to. This operation (Copy
to) is available at the User (Administrator) level.
Note
The Copy to button can be used with KX-NT505 units, even if the number of connected KX-NT505 units
differs between extensions. Settings for NT505 Location No. will be copied to the same number of the
copy target extension. However, if a matching NT505 Location No. does not exist at the target destination,
those settings will not be copied.
For more information on flexible buttons, see "2.21.2 Flexible Buttons" in the Feature Guide.
Once flexible buttons have been programmed, the Terminal Label Print utility can be used to print label sheets,
which can be attached to extension telephones for quick reference. For details, see 1.2.2.1 Editing and
Printing Terminal Labels in Off-line Mode.
To access the Super Master CS for related programming, click SIP-CS Web. The CS Web login screen will
open in your web browser.
Note
For this button to be enabled, you must specify the URL of the Super Master CS in the Utility—CS-Web
Connection screen. See 7.12 Utility—CS-Web Connection.
Type
Specifies the feature to be assigned to the flexible button.
Value Range
Not Stored, Loop CO, Single CO, Group CO, DSS, One-touch, ICD Group, Message Waiting, FWD/DND
(Both), FWD/DND (External), FWD/DND (Internal), Group Fwd (Both), Group Fwd (External), Group Fwd
(Internal), Account, Conference, Terminate, EFA, Charge, Call Park, Call Log, Log-in/Log-out, Hurry-up,
Wrap-up, System Alarm, Time Service, Answer, Release, TRS Level Change, ISDN Service, CLIR, COLR,
ISDN Hold, Headset, Time Service - Automatic/Manual, Check In, Check Out, Cleaned Up, Two-way
Record, Two-way Transfer, LCS, Voice Mail Transfer, NDSS, CTI, PDN, SDN, DN
Notice
For each KX-UT series SIP phone that is connected to the PBX, at least one DN button must be assigned
to the extension. Without a DN button assigned, the extension will not be able to make or receive calls.
664 PC Programming Manual
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
To Next Page
Loading...
