Panasonic KX-NS500 - Page 288

Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Shelf Property
Maximum Bit Rate
Specifies the maximum bit rate of the fax signal.
Value Range
No Speed Limit, 2400 bps, 4800 bps, 7200 bps, 9600 bps, 12000 bps, 14400 bps
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Shelf Property
DTMF
Specifies the type of DTMF tone to be sent out.
Value Range
Inband, Outband (RFC2833), Outband (H.245)
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Shelf Property
Payload Type
Specifies the payload type for DTMF tones using RFC2833. Programming this parameter is only necessary if
DTMF is set to Outband (RFC2833).
Value Range
96–127
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Shelf Property
T38 FAX Max Datagram
Specifies the maximum datagram size when using the T.38 protocol.
Value Range
272–512
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Shelf Property
T38 FAX UDPTL Error Correction – Redundancy
Specifies whether to enable the redundancy feature when using the T.38 protocol.
288 PC Programming Manual
9.11 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Shelf Property