Panasonic KX-NS500 - Page 371

Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T302
Specifies the maximum time allowed between each digit on an incoming call. Applies to overlap receiving.
Value Range
0–600 ´ 100 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T303
Specifies the maximum time that the PBX waits for a reply after sending the SETUP (call setting) message to
ISDN.
Value Range
0–600 ´ 100 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T304
Specifies the maximum time allowed between each digit on an outgoing call. Applies to overlap sending.
Value Range
0–3000 ´ 100 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T305
Specifies the maximum time that the PBX waits for a reply after sending the DISC (disconnection) message
to ISDN.
Value Range
0–3000 ´ 100 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
PC Programming Manual 371
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type