Panasonic KX-NS500 - Page 373

Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T318
Specifies the maximum time that the PBX waits for a reply after sending the Resume message.
Value Range
0–600 ´ 100 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T319
Specifies the maximum time that the PBX waits for a reply after sending the Suspend message.
Value Range
0–600 ´ 100 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T322
Specifies the maximum time that the PBX waits for a reply after sending the Status enquiry message.
Value Range
0–600 ´ 100 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T3D3
Specifies the length of time that the PBX tries to establish L2 in "Permanent" mode.
Value Range
0–3000 ´ 100 ms
Maintenance Console Location
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T3D9
Specifies the length of time that the PBX tries to disconnect L2 in "Call by Call" mode.
PC Programming Manual 373
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type