Forced Release
Enables the PBX to send a forced release signal.
Value Range
Disable, Enable
Maintenance Console Location
9.28 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type Line Signal Setting
Forced Release Pattern
Selects the bit pattern for a forced release signal.
Value Range
A=0/B=0, A=0/B=1, A=1/B=0, A=1/B=1
Maintenance Console Location
9.28 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type Line Signal Setting
Meter Pulse Detection—Mode
Specifies the mode for call charge meter pulses.
Value Range
No Detection: Meter pulses are not sent or received.
Outgoing call only: Sends a call charge meter pulse for outgoing trunk calls.
Both calls: Sends and receives call charge meter pulses.
Maintenance Console Location
9.28 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type Line Signal Setting
Feature Guide References
2.29.1 E1 Line Service
Meter Pulse Detection—Bit Position
Specifies the bit position of a call charge meter pulse.
Value Range
A-bit, B-bit, C-bit, D-bit
Maintenance Console Location
9.28 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type Line Signal Setting
394 PC Programming Manual
9.28 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type Line Signal Setting
To Next Page
Loading...
