Panasonic KX-NS500 - Page 399

Group-l Code Assignment—End of Digit
Specifies the code used to recognise the end of each digit in an ANI number.
Value Range
Undefined, 1–15
Maintenance Console Location
9.29 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type MFC-R2 Setting 1
Group-l Code Assignment—End of Digit Timer
Specifies the length of time that the PBX waits for further signal before detecting the end of digit of an ANI
number.
Value Range
1–15
Maintenance Console Location
9.29 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type MFC-R2 Setting 1
Group-l Code Assignment—G-ll Code Outgoing Call
Specifies the code for sending Group-ll code to the telephone company.
Value Range
1–15
Maintenance Console Location
9.29 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type MFC-R2 Setting 1
Group-l Code Assignment—G-ll Code Incoming Call [1]–[15]
Specifies the destination of incoming trunk calls for each Group-ll code respectively.
Value Range
Undefined, Subscriber, Operator, Collect Call
Maintenance Console Location
9.29 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type MFC-R2 Setting 1
Group-l Code Assignment—Group-ll ANI
Specifies the Group-ll ANI start code.
Value Range
1–15
PC Programming Manual 399
9.29 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type MFC-R2 Setting 1