Panasonic KX-NS500 - Page 487

Note
• This tab is for programming extensions connected to Expansion Units. For information about setting
up Expansion Units, see 9.32 PBX Configuration—[1-1] Configuration—Slot—Expansion Unit1/
Expansion Unit2/Expansion Unit3.
• For further information about programming for KX-T7710 phones, refer to the 2.6.7 KX-T7710
One-touch Dialling in the Feature Guide.
Dial
Indicates the DTMF tone dial required by the PBX to recognise it and dial the pre-programmed number for
each key (reference only).
Value Range
B: For MESSAGE Key
A1: For One-touch Dial 01 Key
A2: For One-touch Dial 02 Key
A3: For One-touch Dial 03 Key
A4: For One-touch Dial 04 Key
A5: For One-touch Dial 05 Key
A6: For One-touch Dial 06 Key
A7: For One-touch Dial 07 Key
A8: For One-touch Dial 08 Key
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
Message Key—Phone Number
Specifies the feature number or telephone number dialled when the MESSAGE key on the KX-T7710 is
pressed. By default, this is set to the feature number used to call back a caller who left a message waiting
indication,
Message Waiting Set / Cancel / Call Back.
This is available only when the position of the Mode switch lever on the KX-T7710 is set to "PBX".
Value Range
Max. 32 digits (consisting of 0–9, *, #, T [Transfer], [ ] [Secret], P [Pause], and F [Flash])
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—
Message Waiting Set /
Cancel / Call Back
One-touch Dial 01–08—Phone Number
Specifies the number dialled when a one-touch key on the KX-T7710 is pressed.
This is available only when the position of the Mode switch lever on the KX-T7710 is set to "PBX".
PC Programming Manual 487
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main