DSS Key—Call Pick-up by DSS key for Direct Incoming Call
Specifies whether a DSS button will light up or flash when a call rings at the specified extension. To enable
this setting, DSS Key—DSS key mode for Incoming Call on this screen must be set to "ON or Flash".
Value Range
Disable: The DSS button will light up when a call arrives, but pressing it will not pick up the call.
Enable: The DSS button will flash when a call arrives, and pressing it will pick up the call.
Maintenance Console Location
10.9 PBX Configuration—[2-9] System—System Options
Feature Guide References
2.4.3 Call Pickup
DSS Key—Call Pick-up by DSS key for ICD Group Call
Specifies whether a DSS button will light up or flash when a call rings at the specified incoming call distribution
group.
To enable this setting,
DSS Key—DSS key mode for Incoming Call on this screen must be set to "ON or
Flash".
Value Range
Disable: The DSS button will light up when a call arrives, but pressing it will not pick up the call.
Enable: The DSS button will flash when a call arrives, and pressing it will pick up the call.
Maintenance Console Location
10.9 PBX Configuration—[2-9] System—System Options
Feature Guide References
2.4.3 Call Pickup
DSS Key—Automatic Transfer for Extension Call
Specifies whether pressing a DSS or SDN button during an extension-to-extension call disconnects the current
call or places the call on consultation hold.
Value Range
Disable: The PBX disconnects the current call, and calls the extension assigned to the DSS or SDN button.
Enable: The PBX places the current call on consultation hold.
Maintenance Console Location
10.9 PBX Configuration—[2-9] System—System Options
Feature Guide References
2.12.1 Call Transfer
532 PC Programming Manual
10.9 PBX Configuration—[2-9] System—System Options
To Next Page
Loading...
