Panasonic KX-NS500 - Page 638

Maintenance Console Location
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
Wireless XDP / Shared Extension
Specifies the extension number of the PS with which Wireless XDP Parallel Mode is established. To enable
Wireless XDP Parallel Mode, the PS must be turned off once and then turned on after assigning this setting.
This setting also specifies the sub extension for the main extension of a one-numbered extension.
Note
When Wireless XDP, S-PSs cannot be used with this setting.
Value Range
Max. 5 digits (consisting of 0–9)
Maintenance Console Location
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
Feature Guide References
2.11.11 One-numbered Extension
5.2.4.5 Wireless XDP Parallel Mode
Ring Pattern Table
Specifies the Ring Tone Pattern Table to be used by the extension.
Value Range
1–8
Maintenance Console Location
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
PC Programming Manual References
10.8.1 PBX Configuration—[2-8-1] System—Ring Tone Patterns—Call from CO
10.8.2 PBX Configuration—[2-8-2] System—Ring Tone Patterns—Call from DOORPHONE
10.8.3 PBX Configuration—[2-8-3] System—Ring Tone Patterns—Call from Others
Feature Guide References
2.1.3.2 Ring Tone Pattern Selection
Programmed Mailbox No.
Specifies the mailbox number of the incoming call distribution group’s mailbox for Voice Processing Systems
(VPS) with DTMF Integration.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
638 PC Programming Manual
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings