Parameter Selection (for Log-in/Log-out)
Specifies which incoming call distribution groups that the extension belongs to are logged in to or logged out
from.
Value Range
None: The incoming call distribution group is selected manually.
All: All incoming call distribution groups that the extension belongs to.
Incoming Group: A pre-specified incoming call distribution group
Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
Feature Guide References
2.2.2.7 Log-in/Log-out
Parameter Selection (for Time Service)
Selects which time modes are switched manually.
Value Range
All (Day/Night/Lunch/Break), Day/Night/Break, Day/Night/Lunch, Day/Night
Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
Feature Guide References
5.1.4 Time Service
Parameter Selection (for TRS Level Change)
Specifies the TRS/Barring level to be used temporarily on a certain extension.
Value Range
Level 1–Level 7
Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
Feature Guide References
2.7.1 Toll Restriction (TRS)/Call Barring (Barring)
2.7.4 Dial Tone Transfer
Parameter Selection (for Time Service - Automatic/Manual)
Specifies the Time Table to be used when the Time Service Switching Mode is set to Automatic.
666 PC Programming Manual
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
To Next Page
Loading...
