Panasonic KX-NS500 - Page 743

Value Range
Busy Tone, Enable, Busy Message
Maintenance Console Location
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System
DISA Intercept—Intercept when all DISA ports are busy
Selects how DISA calls are handled if all DISA ports are currently in use.
Value Range
to Operator, to AA-0, to AA-9, Disable (Busy Tone)
Maintenance Console Location
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System
DISA Intercept—Intercept when No Dial after DISA answers
Selects how DISA calls are handled if the caller does not select any option from the menu.
Value Range
to Operator, to AA-0, to AA-9, Disable (Reorder Tone)
Maintenance Console Location
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System
CO-CO with DISA—DISA to Public CO
Specifies whether the DISA port is released when a trunk-to-public trunk call using DISA is established. To
enable this setting, "
CO-CO with DISA—Fwd/Transfer to Public CO" on this screen should be set to
"Enable".
Setting this to "Disable" will free up DISA ports faster, but prevent DISA being used to detect the end of a call
and disconnect the trunk quickly.
Value Range
Disable (Release DISA): The DISA port is released when a trunk-to-public trunk call using DISA is established.
Enable: DISA stays connected for the duration of the call, to allow detection of the end of the call.
Maintenance Console Location
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System
PC Programming Manual References
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System—Option 1—
CO-CO
with DISA—Fwd/Transfer to Public CO
PC Programming Manual 743
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System