PC Programming Manual References
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System—Option 1— CO-CO
with DISA—DISA to Private Network
CO-CO with DISA—Transfer by DTMF "#" (Activation Key Required)
Specifies whether an outside party such as a cellular phone can transfer a trunk call to an extension within the
PBX by dialling "#" + extension number.
Value Range
Disable: "#" is ignored if dialled.
Enable (as "Flash"): The current trunk call will be placed on hold, then transferred to the extension whose
number is entered.
Maintenance Console Location
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System
CO-CO with DISA—Return to DISA Top Menu by DTMF "*"
Enables a trunk caller to return to the DISA top menu by pressing " " while hearing a ringback, reorder, or
busy tone. If disabled, retrying the call is possible by pressing " ".
Value Range
Disable, Enable
Maintenance Console Location
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System
Option 2
DISA Cyclic Tone Detection
Selects the cyclic tone detection mode. Cyclic tone detection is used to determine the end of a call for a DISA
trunk-to-trunk conversation established through an analogue trunk.
This setting is only available when DPS cards are not installed.
Value Range
Fixed: The number of times of a tone pattern (a set of tone-on and tone-off) that the PBX receives is fixed to
4 times in the ranges of:
, = 100–1300 ms, = 90 ms, = 90 ms
Option: The tone pattern that the PBX receives is optional as specified in DISA Cyclic Tone Option on this
screen.
PC Programming Manual 745
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System
To Next Page
Loading...
