12.2.6 PBX Configuration-[4-1-6]Extension—Portable Station—Simplified Voice Message
Feature Guide References
2.16.3 Built-in Simplified Voice Message (SVM)
SVM Cyclic Tone Detection
Specifies the SVM cyclic tone detection mode.
Value Range
Fixed, Option
Maintenance Console Location
13.3.3 PBX Configuration-[5-3-3] Option Device - Voice Message - SVM
Feature Guide References
2.16.3 Built-in Simplified Voice Message (SVM)
SVM Cyclic Tone Option—Tone On Maximum Time
Specifies the maximum duration of the cyclic tone that will be recognised by the PBX. When the tone sent
fromthe telephone company is shorter than the value set here, the PBX recognises it as a tone-on.
Note that this option can only be set when SVM Cyclic Tone Detection on this screen is set to "Option".
Value Range
20 x n (n=6–200) ms
Maintenance Console Location
13.3.3 PBX Configuration-[5-3-3] Option Device - Voice Message - SVM
PC Programming Manual References
9.1 PBX Configuration—[1-1] Configuration—Slot
Feature Guide References
2.16.3 Built-in Simplified Voice Message (SVM)
SVM Cyclic Tone Option—Tone Off Maximum Time
Specifies the maximum time that the PBX waits for a cyclic tone to be sent from the telephone company before
recognising it as a tone-off. When no tone is detected within the time set here, the PBX recognises it as a
tone-off.
Value Range
20 x n (n=6–200) ms
PC Programming Manual 751
13.3.3 PBX Configuration-[5-3-3] Option Device - Voice Message - SVM
To Next Page
Loading...
