Panasonic KX-NS500 - Page 804

Network Data Transmission for Centralised Operator Feature—Data
Transmission ISDN->VoIP
Selects whether to re-send BLF data received from an ISDN port through any VoIP ports that are set to transmit
BLF data.
Value Range
Disable, Enable
Maintenance Console Location
17.2 PBX Configuration—[9-2] Private Network—Network Data Transmission
PC Programming Manual References
17.3 PBX Configuration—[9-3] Private Network—Network Operator (VoIP)— IP-GW Card Slot No. to notify
BLF data to Network Operator
Feature Guide References
4.2.5.1 Network Direct Station Selection (NDSS)
Network Data Transmission for Centralised Operator Feature—Data
Transmission Counter
Specifies the maximum number of "hops", or transmissions between two PBXs, before a packet of BLF data
is discarded.
Value Range
1–63
Maintenance Console Location
17.2 PBX Configuration—[9-2] Private Network—Network Data Transmission
Feature Guide References
4.2.5.1 Network Direct Station Selection (NDSS)
Network Data Transmission for Centralised Operator Feature—Data
Broadcasting Interval Timer
Specifies the frequency of BLF data transmission. The PBX will send data over the network periodically
according to the interval specified here.
Value Range
100 ´ n (n=0–30) ms
Maintenance Console Location
17.2 PBX Configuration—[9-2] Private Network—Network Data Transmission
804 PC Programming Manual
17.2 PBX Configuration—[9-2] Private Network—Network Data Transmission