Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Guide References
2.1.1.1 Incoming Trunk Call Features—SUMMARY
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
DDI/DID/TIE—Remove Digit
Specifies the number of leading digits to be removed from the incoming called number for DDI/DID distribution
or for TIE line service.
Value Range
0–15
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Guide References
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
4.2.1 TIE Line Service
DDI/DID/TIE—Additional Dial
Specifies the number to be added to the incoming called number in the place of the removed digits for DDI/
DID distribution or for TIE line service.
Value Range
Max. 8 digits (consisting of 0–9, *, and #)
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Guide References
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
4.2.1 TIE Line Service
818 PC Programming Manual
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
To Next Page
Loading...
