4.2 System Programming
DISA Tone Selection after the Security Code
System Programming 4-93
Description Enables or disables sending a beep to a caller after the Security
Code is entered. If enabled, a beep is sent to the caller when the
code entered is the same as one of the security codes assigned in
program [512] “DISA Security Codes”.
Selection Enable / Disable
Default Enable
Programming 1. Enter 518.
Display: DISA Dial Tone
2. Press NEXT.
Display example: Enable
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Conditions None
Feature Reference Section 3, Features
Direct Inward System Access (DISA)
518
To Next Page
Loading...
