5-58
5. Manual Gain Tuning (Application)
Inertia ratio switching function
Related
Parameter
Combine the following 3 parameters to setup appropriate inertia ratio switching function.
Class No.
Title Function
6 10
Function
expansion setup
Sets bits related to inertia ratio switching function.
bit1 0: Invalid 1: Valid
bit2 0: Always valid 1: Valid
only when 1st gain is selected.
* bit 0 = LSB
Example)
To enable inertial ratio switching
Setup value = 8
0 04 Inertia ratio
Set 1st inertia ratio.
You can set up the ratio of the load inertia against the rotor (of
the motor) inertia.
6 13 2nd Inertia ratio
Set 2nd inertia ratio.
You can set up the ratio of the load inertia against the rotor (of
the motor) inertia.
How to Use
• Select 1st inertia ratio or 2nd inertia ratio according to the inertia ratio select input (J-SEL).
Inertia ratio switching
input (J-SEL)
Applicable inertia ratio
OFF 1st Inertia ratio (Pr0.04)
ON 2nd Inertia ratio (Pr6.13)
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
