Panasonic PV500 - Page 400

398
Control with Communication Port
Chapter 9
Inspection start
When using common trigger in “Execute All” or “Automatic
Switch” execution mode
Send
%
S
BCC
CR
BCC = 76 or **
Receive
%
S
$
BCC(52)
CR
Error (ERROR 0 signal = ON)
%
S
!
Error code (3-digit)
BCC
CR
Error code
160
Position adjustment for a detect trigger is unset or a base position is unset
when "Camera Trigger" is set to “Detect Trigger (common)”.
200
Operation is stopped.
201
“Camera Trigger” in “Camera” is set to “Individual".
202
Execution mode is “User-Defined”.
203
No camera is connected.
When using common trigger in “User-Defined” execution
mode
Send
%
S
?
BCC
CR
? = 0 - 9 (Block No. to execute)
Receive
%
S
$
BCC(52)
CR
Error (ERROR 0 signal = ON)
%
S
!
Error code (3-digit)
BCC
CR
Error code
160
Position adjustment for a detect trigger is unset or a base position is unset
when "Camera Trigger" is set to “Detect Trigger (common)”.
200
Operation is stopped
201
• Execution mode is NOT “User-Defined” in PV500.
• “Camera Trigger” in “Camera” is set to “Individual”.
202
The specified block is invalid (the number which does not/ cannot exist was
specified)
203
• No camera is connected.
• The specified camera number is set to "Unused" in PV500.
Example: Starts the inspection of block No.2.
Send
%
S
2
*
*
CR
Receive
%
S
$
5
2
CR