AS-Interface
Table of contents
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 24.4.2007
2
6.2.6.1 Programming slave 2 to address 6 ....................................................................26
7 Operating in Advanced Display Mode ............................................. 27
7.1 EtherNet/IP (main menu) .................................................................................30
7.1.1 ARM Firmware ...................................................................................................30
7.1.2 TCP/IP Object ....................................................................................................30
7.1.2.1 IF Status ............................................................................................................31
7.1.2.2 IF Capability .......................................................................................................31
7.1.2.3 IF Control ...........................................................................................................31
7.1.2.4 Path to Link Object .............................................................................................31
7.1.2.5 TCP/IP configuration ..........................................................................................32
7.2 Ethernet Object ................................................................................................32
7.3 Quick setup ......................................................................................................33
7.3.1 Control menu (option) ........................................................................................34
7.3.1.1 AS-i control ........................................................................................................34
7.3.1.2 AS-i control information ......................................................................................34
7.3.1.3 AS-i control run ..................................................................................................34
7.3.1.4 AS-i control flags (flag memory control program) ..............................................35
7.4 Slave Adr Tool (slave addressing tool) ..........................................................35
7.5 Slave Test Tool .................................................................................................36
7.6 Setup (configuration of AS-i circuit) ..............................................................38
7.6.1 AS-i circuit ..........................................................................................................38
7.6.2 Description of setup mode .................................................................................38
7.6.3 AS-i Slave Adr (set/change slave address) .......................................................39
7.6.4 Force offline .......................................................................................................39
7.6.5 Operation mode .................................................................................................39
7.6.6 Store Act Cfg (store actual detected configuration) ...........................................40
7.6.7 Permanent Param (projected parameter) ..........................................................40
7.6.8 Permanent Config (projected configuration data) ..............................................40
7.6.9 AS-i address assistent .......................................................................................41
7.6.10 LOS (list of offline slaves) ..................................................................................41
7.6.11 Auto Adr Enable (enable automatic address) ....................................................41
7.6.12 Factory reset ......................................................................................................42
7.7 IO + Param. Test ...............................................................................................42
7.7.1 AS-i circuit ..........................................................................................................42
7.7.2 IO + Param. Test (Testing AS-i In- and Outputs as well as reading and
writing AS-i Parameters) ....................................................................................43
7.7.3 Binary input ........................................................................................................43
7.7.4 Binary outputs ....................................................................................................44
7.7.5 Analog inputs .....................................................................................................44
7.7.6 Analog outputs ...................................................................................................45
7.7.7 Parameter ..........................................................................................................45
7.8 Diagnosis (normal AS-i diagnosis) ................................................................46
7.8.1 AS-i circuit ..........................................................................................................46
7.8.2 Diagnosis (normal AS-i diagnosis) .....................................................................46
7.8.3 Flags ..................................................................................................................47
7.8.4 Actual Config (actual configuration) ...................................................................49
7.8.5 LPF (List of periphery faults) ..............................................................................49
7.8.6 AS-i master (info) ...............................................................................................50
To Next Page
Loading...
