Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 500 automated external defibrillator Replacement Procedures
11-16
Restoring User-Defined Setups
Restore user-defined and service setups whenever you replace the Main PCB
assembly. Use the User Defined Setups Log Sheet, if available, to restore
user-defined setups.
Note: If the operating system loader is capable of automatically restoring a setup
image (possible in situations where the loader could read the AED’s flash
RAM—monophasic operating system version 4.41 and later; all biphasic
versions), it is still important to confirm that setups are properly restored.
Refer to the LIFEPAK 500 Setup Instructions for detailed information about
observing and re-entering the recorded user-defined setups.
To Next Page
Loading...
