Planet WGSW-20160HP - Spanning-Tree Link-Type; Spanning-Tree Mst <Instance: 0-7> Cost

Command Guide
-158-
4.2.65.116 spanning-tree link-type
Command:
spanning-tree link-type auto | point-to-point | shared
spanning-tree Spanning Tree protocol
link-type Port link-type
auto Auto detect
point-to-point Forced to point-to-point
shared Forced to Shared
Default:
Auto
Usage Guide:
To configure point to point mode of CIST Normal Port Configuration for specific interface
Example:
To enable point to point mode (shared) of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree edge
4.2.65.117 spanning-tree mst <Instance : 0-7> cost
Command:
spanning-tree mst <Instance : 0-7> cost <Cost : 1-200000000> | auto
spanning-tree Spanning Tree protocol
mst STP bridge instance
<Instance : 0-7> instance 0-7 (CIST=0, MST2=1...)
cost STP Cost of this port
<Cost : 1-200000000> Cost range
auto Use auto cost
Default:
Auto
Usage Guide:
To configure Path Cost of CIST / MST Normal Port Configuration for specific interface
Example:
To enable Path Cost (100) of CIST / MST Normal Port Configuration (CIST) for GigabitEthernet X/X