Planet WGSW-20160HP - Lldp Reinit

Command Guide
-234-
lldp LLDP configurations.
med Media Endpoint Discovery
media-vlan-policy Use the media-vlan-policy to create a policy, which can be assigned to an interface.
<Index : 0-31> Policy id for the policy which is created.
guest-voice Create a guest voice policy.
guest-voice-signaling Create a guest voice signaling policy.
softphone-voice Create a softphone voice policy.
streaming-video Create a streaming video policy.
video-conferencing Create a video conferencing policy.
video-signaling Create a video signaling policy.
voice Create a voice policy.
voice-signaling Create a voice signaling policy.
tagged The policy uses tagged frames.
untagged The policy uses un-tagged frames.
<vlan_id> The VLAN the policy uses tagged frames.
dscp Differentiated Services Code Point.
<0-63> DSCP value 0-63
l2-priority Layer 2 priority.
<0-7> Priority 0-7
Default:
0
Usage Guide:
To configure media-VLAN-policy of LLDP-MED
Example:
To configure media-VLAN-policy as below table of LLDP-MED
Switch# configure terminal
Switch (config)# lldp med media-vlan-policy 1 guest-voice tagged 1 dscp 45 l2-priority
5
4.2.112 lldp reinit
Command:
lldp reinit <1-10>
lldp LLDP configurations.
reinit LLDP tx reinitialization delay in seconds