Planet WGSW-20160HP - Snmp-Server Community; Snmp-Server Contact

Command Guide
-301-
4.2.209 snmp-server community
Command:
snmp-server community { v2c
<comm> [ ro | rw ] | v3 <v3_comm> [ <v_ipv4_addr>
<v_ipv4_netmask> ] }
snmp-server Set SNMP server's configurations
community Set the SNMP community
v2c SNMPv2c
<comm> Community word
ro Read only
rw Read write
v3 SNMPv3
<V3Comm : word127> Community word
<ipv4_addr> IPv4 address
<ipv4_netmask> IPv4 netmask
Default:
None
Usage Guide:
To configure the Read / Write / Source network Community of SNMP
Example:
To configure the Read / Write / Source network Community (below table) of SNMP
Switch# configure terminal
Switch (config)# snmp-server community v3 public 192.168.0.15 255.255.255.0
4.2.210 snmp-server contact
Command:
snmp-server contact <line255>
snmp-server Set SNMP server's configurations
contact Set the SNMP server's contact string
<line255> contact string