Planet WGSW-20160HP - Ip Igmp Snooping Query-Max-Response-Time; Ip Igmp Snooping Robustness-Variable

Command Guide
-180-
4.2.66.15 ip igmp snooping query-max-response-time
Command:
ip igmp snooping query-max-response-time <IpmcQi : 1-31744>
ip Interface Internet Protocol config commands
igmp Internet Group Management Protocol
snooping Snooping IGMP
query-max-response-time Query Response Interval in tenths of seconds
<IpmcQri : 0-31744> 0 - 31744 tenths of seconds
Default:
125
Usage Guide:
To configure Querier-interval of IGMP snooping for specific VLAN
Example:
To configure Querier-interval (60 seconds) of IGMP snooping for VLAN X
Switch# configure terminal
Switch (config)# interface vlan X
Switch (config-if-vlan)# ip igmp snooping query-max-response-time 600
4.2.66.16 ip igmp snooping robustness-variable
Command:
ip igmp snooping robustness-variable <IpmcRv : 1-255>
ip Interface Internet Protocol config commands
igmp Internet Group Management Protocol
snooping Snooping IGMP
robustness-variable Robustness Variable
<IpmcRv : 1-255> Packet loss tolerance count from 1 to 255
Default:
2
Usage Guide:
To configure Robustness Variable of IGMP snooping for specific VLAN
Example:
To configure Robustness Variable (88) of IGMP snooping for VLAN X