Planet WGSW-20160HP - Show Loop-Protect

Command Guide
-392-
Usage Guide:
To display the Syslog information.
Example:
To display the Syslog information with Log ID 235861.
Switch # show logging 235861
Switch : 1
ID : 235861
Level : Warning
Time : 1970-01-01T13:33:57+00:00
Message:
Loop Detected: Port 5 shut down
4.21.66 show loop-protect
Command:
show loop-protect [ interface ( <port_type> [ <port_list> ] ) ]
show Show running system information
loop-protect Loop protection configuration
interface Interface status and configuration
Default:
N/A
Usage Guide:
To display the Loop protection information.
Example:
To display the Loop protection information for GigabitEthernet 1/1.
Switch # show loop-protect interface GigabitEthernet 1/1
Loop Protection Configuration
======================================
Loop Protection : Enable
Transmission Time : 2 sec
Shutdown Time : 2 sec
GigabitEthernet 1/1
------------------------------
Loop protect mode is enabled.
Actions are both of shutdown and log.