Planet WGSW-20160HP - Mep <Instance> Performance-Monitoring; Mep <Instance> Tst

Command Guide
-254-
4.2.142 mep <Instance> performance-monitoring
Command:
mep <Instance> performance-monitoring
mep Maintenance Entity Point
<Instance> The MEP instance number.
performance-monitoring Performance monitoring Data Set collection (MEF35)
Default:
Disabled
Usage Guide:
To enable Performance Monitoring of MEP.
Example:
To enable Performance Monitoring of MEP 1
Switch# configure terminal
Switch (config)# mep 1 performance-monitoring
4.2.143 mep <Instance> tst
Command:
mep <Instance> tst <prio> [ dei ] mep-id <mepid> [ sequence ] [ all-zero | all-one |
one-zero ] rate <rate> size <size>
mep Maintenance Entity Point
<Instance> The MEP instance number.
tst Test Signal
<Prio : 0-7> Priority in case of tagged OAM. In the EVC domain this is the COS-ID.
dei Drop Eligible Indicator in case of tagged OAM.
mep-id Peer MEP-ID for unicast TST. The MAC is taken from peer MEP MAC database.
<Mepid : uint> Peer MEP-ID value
sequence Enable sequence number in TST PDU
all-one Test pattern is set to all one.
all-zero Test pattern is set to all zero.
one-zero Test pattern is set to 10101010.
rate The TST frame transmission bit rate - in Mega bits pr. second. Limit on Caracal is 400 Mbps. Limit on Serval is
1Gbps. This is the bit rate of a standard frame without any encapsulation. If 1 Mbps rate is selected in a EVC
MEP, the added tag will give a hi
<Rate : uint> Transmission rate value