Planet WGSW-20160HP - Vlan Protocol

Command Guide
-325-
<etype> Ethertype (Range: 0x0600-0xffff)
Default:
0x88A8
Usage Guide:
To create the Ethernet type of Custom S-ports
Example:
To create the Ethernet type (0x88A9) of Custom S-ports
Switch# configure terminal
Switch (config)# vlan ethertype s-custom-port 0x88a9
4.2.227 vlan protocol
Command:
vlan protocol { { eth2 { <etype> | arp | ip | ipx | at } } | { snap { <oui> | rfc-1042 |
snap-8021h } <pid> } | { llc <dsap> <ssap> } } group <grp_id>
vlan VLAN commands
protocol Protocol-based VLAN commands
eth2 Ethernet-based VLAN commands
<0x600-0xffff> Ether Type(Range: 0x600 - 0xFFFF)
arp Ether Type is ARP
at Ether Type is AppleTalk
ip Ether Type is IP
ipx Ether Type is IPX
llc LLC-based VLAN group
<0x0-0xff> DSAP (Range: 0x00 - 0xFF)
<0x0-0xff> SSAP (Range: 0x00 - 0xFF)
snap SNAP-based VLAN group
<0x0-0xffffff> SNAP OUI (Range 0x000000 - 0XFFFFFF)
rfc-1042 SNAP OUI is rfc-1042
snap-8021h SNAP OUI is 8021h
group Protocol-based VLAN group commands
<grp_id> Group Name (Range: 1 - 16 characters)
Default:
None
Usage Guide:
To configure the Protocol-based VLAN