Planet WGSW-20160HP - Show Dot1 X Status

Command Guide
-352-
4.21.11 show dot1x status
Command:
show dot1x status [ interface ( <port_type> [ <v_port_type_list> ] ) ] [ brief ]
show Show running system information
dot1x IEEE Standard for port-based Network Access Control
status Shows dot1x status, such as admin state, port state and last source.
interface Interface
brief Show status in a brief format
Default:
N/A
Usage Guide:
To display the IEEE 802.1X status.
Example:
To display the All of IEEE 802.1X status for brief.
Switch # show dot1x status
GigabitEthernet 1/1 :
---------------------
Admin State Port State Last Source Last ID
------------------ --------------------- ----------------- -------------
Force Authorized Globally Disabled - -
Current Radius QOS Current Radius VLAN Current Guest VLAN
-------------------- -------------------- --------------------
- - -
GigabitEthernet 1/2 :
---------------------
Admin State Port State Last Source Last ID
------------------ --------------------- ----------------- -------------
Force Authorized Globally Disabled - -
Current Radius QOS Current Radius VLAN Current Guest VLAN
-------------------- -------------------- --------------------
- - -