Planet WGSW-20160HP - Ipv6 Route

Command Guide
-221-
4.2.101 ipv6 route
Command:
Ipv6 route <X:X:X:X::X/<0-128>> {<X:X:X:X::X>, interface vlan <vlan_id>
<FE80::X:X:X >}
ipv6 IPv6 configuration commands
route Add IP route
<X:X:X:X::X/<0-128>> IPv6 prefix x:x::y/z
<X:X:X:X::X> IPv6 unicast address (except link-local address) of next-hop
interface Select an interface to configure
vlan VLAN Interface
<vlan_id> VLAN identifier(s): VID
<FE80::X:X:X> IPv6 link-local address of next-hop
Default:
None
Usage Guide:
To configure static route for IPv6
Example 1:
To configure static route as below table for IPv6.
Switch# configure terminal
Switch (config)# ipv6 route 2001::7788/128 2002::1
Example 2:
To configure static route as below table for IPv6.
Switch# configure terminal
Switch (config)# ipv6 route 2001::7788/128 interface vlan 1 fe80::1